Hoop size 100x100 mm ≈3.9 x 3.9 inches;
Formats: .dst, .jef, .pec, .vip, .hus, .pes, .exp, .sew, .dat, xxx
Step one - Hooping the stabilizer
Take the necessary piece of water-soluble stabilizer and hoop it into the embroidery frame. If you use a less dense stabilizer like Madeira Avalon
Ultra, fold it into three or four layers to give the embroidery a special density.
Step two - Embroidery
This process does not differ from the embroidery of other products.
Step three - Trimming the excess stabilizer
Cut off the excess stabilizer, retreating approximately 0.1 or 0.3 inches from the edge of the embroidery.
Step four - Washing the stabilizer
Make sure that the stabilizer is well washed off. At the same time, it is important not to overexpose them, so that in the end, the embroidery kept its shape and was rigid enough.
• This product may be used to create limited products for sale. Bulk product manufacturing is not permitted. Please don't sell or trade the embroidery file.
This design has been tested and reviewed to ensure top quality. Test stitch the design, or portions of it, before stitching it onto your final item, as results may vary depending on fabric and stabilizer combination.